I'm using the Doepfer A-100 DIY kit, and I'd like to use the external switch plate shown here:
https://synthracks.com/shop/panel-switc ... M-BQeREyqP:
However, it says it's a DC inlet (A-100 says it is AC). I'm hoping to connect the external transformer (wall wort) to the switch panel via barrel jack, and then the switch panel would connect to the A-100 via wire to terminal. This is probably a naive question but is this unit usable with the Doepfer A-100 Kit? If not, does anyone know of a switch panel that would work with the A-100?
I also don't see exactly how to connect the switch panel to the A-100. I see the two terminals but they're not labeled positive or negative. I assume they need to be connected with the right polarization.
Any input would be greatly appreciated.
https://synthracks.com/shop/panel-switc ... M-BQeREyqP:
However, it says it's a DC inlet (A-100 says it is AC). I'm hoping to connect the external transformer (wall wort) to the switch panel via barrel jack, and then the switch panel would connect to the A-100 via wire to terminal. This is probably a naive question but is this unit usable with the Doepfer A-100 Kit? If not, does anyone know of a switch panel that would work with the A-100?
I also don't see exactly how to connect the switch panel to the A-100. I see the two terminals but they're not labeled positive or negative. I assume they need to be connected with the right polarization.
Any input would be greatly appreciated.
Statistics: Posted by Andyfoo — Sat Dec 07, 2024 7:41 pm — Replies 1 — Views 61