I need some help and I'm hoping someone around here might be able to assist. Basically I'm building a Mutable Instruments Shruthi XT, and the build portion of it went fine, but now that I'm at the part where I need to burn the firmware and bootloader into the ATMEGA 644p CPU, I'm completely and utterly lost. I've never used an AVR ISP programmer before, but if I can get some basic direction I should be able to figure out the rest. Unfortunately the "instructions" from Mutable Instruments leave a lot to be desired, especially when it comes to how to get the bootloader into the CPU.
Here is a link to the Mutable Instruments instructions page, if anyone can help me get the ball rolling I would be extremely grateful.
https://pichenettes.github.io/mutable-i ... /firmware/
Here is a link to the Mutable Instruments instructions page, if anyone can help me get the ball rolling I would be extremely grateful.
https://pichenettes.github.io/mutable-i ... /firmware/
Statistics: Posted by Midphase — Fri May 31, 2024 9:17 pm — Replies 0 — Views 3